Lunatone DALI phase dimmer (300W)
Product information "Lunatone DALI phase dimmer (300W)"
DALI phase dimmer for retrofit lamps
and other loads such as ohmic resistors, inductors and/or other capacities of 10W - 300W.
The universal Lunatone DALI phase dimmer for retrofit light sources is also suited for ohmic, inductive and capacitive loads. The universal dimmer is supplied as a trailing edge dimmer for capacitive loads. After having applied the mains voltage, any connected inductive load is identified by the universal dimmer and switched to leading edge dimming.Are you looking for a phase dimmer with DALI input for smaller loads? Then select one which can be used for outputs of 3W - 25W.
Product features
- For example, for dimming 230V LED retrofit lamps via DALI (device type 4, firmware 3.0 and higher).
- The minimum dimming level (MIN LEVEL) can be adjusted via DALI.
- Conversion of the DALI 8 bit arc power level into the corresponding phase voltage with trailing edge control or leading edge control.
- Module to integrate “dimmable” 230V light sources into a DALI circuit.
- Double terminals for the simple through-connection of the DALI bus.
- The module represents a bus user and can be addressed accordingly.
- Designed for loads of 10W up to 300W.
- Four different types available.
- Modell HS for Top-Hat Rail Mounting
Technical data
- Typical current consumption: 6mA
- Power supply: via DALI bus
- Number of DALI addresses used: 1
- Input: DALI
- Trailing/leading edge phase angle: 0°- 180°
- Mains voltage: 230V at 50Hz
- Temperature range: -20 °C - +50 °C
- Output load range: 10W - 300W
- Assembly: ceiling installation
- Dimensions (LxWxH): 120x30x20 mm
- Cross-section of connecting wires: 1.5 - 2.5 mm2
Variants with the following specifications are available:
Leading edge control: 86458618-300
Trailing edge control: 86458619-300
Universal dimmer: 86458619-300U
Trailing edge control: 86458619-300
Universal dimmer: 86458619-300U
| Application/IP-Code: | IP20 - IP44 (Indoor) |
|---|---|
| Dimmable/Control: | DALI, Phase-Cut (Triac) |
Login
10 July 2022 18:46
Top Service und Kompetenz
17 February 2023 18:49
n/a
sw_similar
Phase Dimmer (up to 25W) with DALI control input 86458619
€75.09*
DALI Phase Dimmer 86458619 from Lunatone for Loads of 3W-25W
The PD module is a DALI phase dimmer with a DALI control input which is suitable for switching and dimming of light sources. It is especially suitable for controlling dimmable LED lamps with up to 25W, for example.
Example use: Integration of 230V~ LED lights with Edison base in the DALI system, e.g. chandeliers with 7x 3W candle lamps.
Are you looking for a DALI phase dimmer with a DALI input for bigger loads? Then choose one suitable for loads of between 10W-300W now.
Product features DALI PD
Doubled connection terminals for the straightforward looping through of the DALI bus.
For loads of 3-25W (PD)
The minimum dim level (MIN LEVEL) can be set via DALI
Conversion of the DALI 8-Bit ArcPower level into an appropriate phase voltage with phase angle or phase alignment
Module for integration of 230V light sources designated as dimmable in a DALI circuit
Dimming of for example 230V LED retrofit lamps via DALI (Device Type 4 from firmware 3.0)
The module represents a participant on the bus and can be addressed accordingly
Technical data
Supply: via DALI bus
Typical power consumption: 6 mA
Input: DALI
Dimming: 1 % - 100 %
Number of DALI addresses used: 1
Network voltage: 230 VAC
Phase angle / phase alignment: 0° +- 180°
Output load range: 3 W - 25 W
Temperature range 0 °C - 50 °C
Dimensions (LxWxH): 59mm x 33mm x 15mm
Use / installation: Box
Connection wires cross-section: 0.5 - 1.5 mm2
These versions are available with the following specifications:
Leading edge control: 86458618-25
Trailing edge control: 86458619-25
Universal dimmer: 86458619-25U
Variants from €76.65*